29
If the system identifies a valid electronic
key on the outside of the car, by
pressing the button (G) fig. 19 the
tailgate can be locked with all doors
and the boot itself.
WARNING Boot opening is disabled
while the car is moving.
System activation / deactivation
The Passive Entry system can be
activated/deactivated using the display
menu or on the Uconnect™ system
(see "Settings" in the "Vehicle mode"
paragraph in the "Multimedia" section).
DEAD LOCK DEVICE
(where provided)
14)
This safety device inhibits the operation
of the interior buttons of the car and
the door lock/unlock door button.
It thereby prevents the opening of
the doors from inside the passenger
compartment, serving as an obstacle
to break-in attempts.
We recommend that you activate the
device each time you park your car.
Activating the device
The device is activated on all doors by
pressing button on the key twice
in rapid succession or, for cars with
Passive Entry, by pressing the lock
button on the exterior handle of the
driver’s door.
The direction indicators flash 3 times to
let you know that the device is active.
If one or more of the doors are not
closed correctly, the device will not
activate, thus preventing a person from
getting stuck inside the passenger
compartment by entering the car
through, and then closing, the open
door.
Deactivating the device
The device disengages automatically:
when the doors are unlocked
(pressing button on the key with
remote control);
when the ignition device is set to
ENGINE;
by pressing the door opening button
on the outside handle on the driver’s
door in the case of a car equipped with
the Passive Entry system.
The horn is still active even when the
ignition device is in the OFF position.
EMERGENCY CLOSING
AND OPENING
If the electronic key does not work, e.g.
if the battery of the key is low, you can:
unlock the car using the mechanical
key inside the electronic key by acting
on the pawl located on the driver's
door. See the "Emergency opening
of the doors from outside" paragraph
below.
Lock the car by pressing the door
open button (B) fig. 17 placed on the
inner door panel for about 5 seconds
keeping the ignition device in STOP
position and the door open.
The car will lock all the doors and the
tailgate after about 5 seconds.
The LED on the door button (B) fig. 17
and on the centre dashboard (A) fig. 16
will light up to notify the locking.
When the last door is closed the car will
be locked.
The car can be locked from any door,
respecting the manoeuvre described
above.
5)
Opening and locking
doors in the event of
power failure
If the 12V battery of the car is flat, the
doors can still be opened or locked as
they are equipped with an additional
power supply.
Opening the doors
You can open the door in the following
ways:
with the doors locked, press the
door opening button (E) fig. 18 on the
external handle of the driver’s door
three times within 2 seconds.
To Next Page
Loading...
