Configuration
IM/265Gx/Ax-EN-07 265Gx, 265Ax 61
7.6.1.7 "ALARM CURRENT" parameter
Not with fieldbus transmitters
7.6.1.8 "DISPLAY" parameter
Select LCD di
splay value 1, 2, or 3 (permanent display).
The following values can be displayed:
• Output signal in physical unit
265G: Current measured value for gauge pressure, or variable derived from this, such as the
fill level
265A: Current measured value for absolute pressure; with customized unit; corresponds to
"OUT" with PROFIBUS PA
Setting changes under "OUT 0%" and "OUT 100 %"; desired unit under "UNIT_OUT"
• Percentage value of output signal
• Output current (not with fieldbus transmitters)
7.6.1.9 "UNIT - p/dp" parameter
Selection li
st of pressure units for the pressure/differential pressure detected by the sensor,
including for LCD display code no. 8 under "VIEW"
7.6.1.10 "UNIT - OUT" parameter
Selection li
st of "OUT" units (for output variables, e.g., m
3
,
m, l/h)
including for LCD display code no. 1 under "VIEW" or "DISPLAY"
7.6.1.11 "CUSTOM" parameter
Activation/de
activation of a freely programmable characteristic
7.6.1.12 "ADDRESS" parameter
Only with fieldbus
transmitters
To Next Page
Loading...
