Configuration
60 265Gx, 265Ax IM/265Gx/Ax-EN-07
7.6.1 Parameter description
7.6.1.1 "VIEW" parameter
Temporary display of display values 1 to 9.
The following measured values can be set:
• Output signal in physical unit
265G: Current measured value for gauge pressure, or variable derived from this, such as the
fill level
265A: Current measured value for absolute pressure; both with customized unit,
corresponds to "OUT" with PROFIBUS PA
Setting changes under "OUT 0%" and "OUT 100 %"; desired unit under "UNIT_OUT"
• Percentage value of output signal
• Output current (not with fieldbus transmitters)
• Pressure (current pressure value in range between lower and upper range limit values set).
Setting changes under "GET 0 % / 100 %" or "SET 0 % / 100 %"; desired unit under
"UNIT_p/dp".
• Sensor temperature
7.6.1.2 "GET 0 %" and "GET 100 %" parameters
Setting with applied p
ressure
7.6.1.3 "SET 0%" and "SET 100 %" parameters
Setting witho
ut applied pressure
7.6.1.4 "SHIFT ZERO" parameter
Zero
shift and zero position correction
7.6.1.5 "OFFSET SHIFT" parameter
Offs
et shift
7.6.1.6 "OUT 0 %" and "OUT 100 %" parameters
Setting for ou
tput variables
(including LCD "VIEW", display code no.1, and "DISPLAY", display code no. 1)
To Next Page
Loading...
