ABB AC500 V3 - Execution of Update Via Memory Card

5. On the right side, select and open the folder “sdcard”.
6.
On the left side, select all the subfolders and files of the MEMORY CARD folder, but not
the folder itself.
7. Copy all selected subfolders and files from the left side to the memory card by clicking
to the right side.
1.
Insert the memory card into the PC.
2. Mark all subfolders and files of the "MEMORY CARD" folder, but not the "MEMORY
CARD" folder itself, and copy them.
3. Select the memory card and paste the copied subfolders and files.
14.2.2
Execution of update via memory card
Precondition: Prepared memory card with boot project and firmware
Ä Chapter 14.2.1
“Preparation of memory card” on page 108.
1. Switch off the device.
2. Insert the memory card.
Copy process
on the PC
Boot project
and firmware
update
Appendix
PLC firmware/application update via memory card > Execution of update via memory card
2023/03/03 3ADR011074, 1, en_US 111