ABB AC500 V3 - Preface; Guidance through the Documentations; Do I Have AC500 V2 or AC500 V3

—
1
Preface
1.1 Guidance through the documentations
Where to find information about:
●
PLC system
– System description
Ä Chapter 3 “System overview” on page 12
–
Getting started: First steps with the platform and create your first program
– Starter kit: Introduction into PLC programming using pre-installed kits, including creation
of control panel visualization
– Safety user manual for safety PLCs
●
Devices
–
Data sheets
– Installation instructions
– PLC hardware descriptions
– Safety user manual for safety PLCs
– Control panels
●
Software and programming
–
Engineering suite Automation Builder
– Programming examples for download
–
Programming examples available in engineering suite: Open Automation Builder menu
“Help è Project examples”
–
Application descriptions for specific features and use cases
– Release notes for the latest version of the engineering suite Automation Builder
1.2 Do I have AC500 V2 or AC500 V3?
This document describes AC500 V3 products.
W
e offer different ranges of the processor modules (V2, V3). You can easily find out which ones
are used in your system. Either have a look at your used modules or your configuration.
Fig. 1: Hardware: Processor modules
Written type on the module Example Range Relevant manual
Processor module type PM +
3 digits
PM595 V2 AC500 V2
Processor module type PM +
4 digits
PM5670 V3 AC500 V3 (this manual)
Preface
Do I have AC500 V2 or AC500 V3?
2023/03/033ADR011074, 1, en_US4