Updating the firmware and the application on a processor module is the same process than
installing a firmware and an application on a very new processor module.
The installation can be performed either via the engineering suite Automation Builder (recom-
mended, for details refer to the
software manual) or via memory card
Ä
Chapter 14.2 “PLC
firmware/application update via memory card” on page 108.
Fig. 26: The “Version information” tab of a device in Automation Builder
9.3 Control panel firmware/application update
The system components can be updated via Panel Builder software or via USB flash drive.
Refer to the Panel Builder manual for a detailed description.
9.4
Reset to factory settings
PLC is in STOP mode.
1.
Press and hold (> 5 sec) [RUN].
ð
RUN LED = ON.
“Reset” is displayed.
2.
Press [OK] to reset
+
the PLC.
The factory restore of a control panel is described in the
Panel Builder manual.
PLC
Control panel
Reset to factory settings
2023/03/03 3ADR011074, 1, en_US 87
To Next Page
Loading...
