ABB AC500 V3 - Compatibility of Hot Swap

Device Min. required device index for I/O module as of
FW V
ersion 3.0.14
DO524 (-XC) A3
DO526 A2
DO526-XC A0
DO561 B2
DO562 A2
DO571 B3
DO572 B2
DO573 A1
DX522 (-XC) D2
DX531 D2
DX561 B2
DX571 B3
FM562 A1
11.2.2 Compatibility of hot swap
Hot swap is not supported by AC500-eCo V3 CPU!
Central I/O on V3 CPU
I/O module on TU5xx-H connected to I/O bus
master
AC500 V3 CPU types:
PM56xx-2ETH
Required version of I/O bus master Firmware as of V3.2.0
Fieldbus master when used as remote I/O with
AC500 V3
-
When used as remote I/O on third party
controller
(PLC or DCS)
-
Maintenance
Replace an I/O module with hot swap > Compatibility of hot swap
2023/03/033ADR011074, 1, en_US94