2. While pressing down I/O module pull it away from DIN rail.
NOTICE!
Risk of function faults!
Missing electrical contact by isolating screws or washers!
Use metal screws on the metal plate.
The metal plate must be included into the grounding concept of the plant.
Do NOT use insulating washers!
One TA566 wall mounting accessory is needed per S500-eCo I/O module.
1. Snap in the TA566 at the back side of the I/O module.
Mounting I/O
modules on a
metal plate
Mechanical planning and installation
Mounting and demounting the S500-eCo I/O module
2023/03/033ADR011074, 1, en_US48
To Next Page
Loading...
