NameStandard
Electromagnetic compatibility (EMC) – Part 6-7: Generic stand-
ards – Immunity requirements for equipment intended to perform
functions in a safety-related system (functional safety) in indus-
trial locations
IEC 61000-6-7:2014
Electrical equipment for measurement, control and laboratory
use – EMC requirements – Part 3-1: Immunity requirements for
safety-related systems and for equipment intended to perform
safety-related functions (functional safety) – General industrial
applications
IEC 61326-3-1:2017
Functional safety of electrical/electronic/programmable electronic
safety-related systems – Part 1: General requirements
IEC 61508-1:2010
Functional safety of electrical/electronic/programmable electronic
safety-related systems – Part 2: Requirements for electrical/elec-
tronic/programmable electronic safety-related systems
IEC 61508-2:2010
Functional safety – Safety instrumented systems for the process
industry sector
IEC 61511-1:2016
Adjustable speed electrical power drive systems – Part 5-2:
Safety requirements – Functional
IEC 61800-5-2:2016
EN 61800-5-2:2007
Safety of machinery – Functional safety of safety-related electric-
al, electronic and programmable electronic control systems
IEC 62061:2005 + A1:2012 +
A2:2015
EN 62061:2005 + AC:2010 +
A1:2013 + A2:2015
Safety of machinery – Safety-related parts of control systems –
Part 1: General principles for design
EN ISO 13849-1:2015
Safety of machinery – Safety-related parts of control systems –
Part 2: Validation
EN ISO 13849-2:2012
The function also corresponds to Prevention of unexpected start-up as specified by
EN ISO 14118:2018 (ISO 14118:2017), and Uncontrolled stop (stop category 0) as
specified in EN/IEC 60204-1.
￭ Compliance with the European Machinery Directive
See the technical data.
The Declaration of conformity is shown at the end of this chapter.
182 The Safe torque off function
To Next Page
Loading...
