Unpacking the delivery
Make sure that all of the items are present and that there are no signs of damage.
Standard drive package contents:
• Drive
• Assistant control panel (not installed)
• RIIO-01 I/O & EIA-485 module (not installed)
• Mounting template (for drives with frame size R3 or R4)
• Installation accessories (cable clamps, etc.)
• Options, if ordered with a plus code. Note that if a fieldbus adapter is ordered, it
replaces the RIIO-01 I/O & EIA-485 module of the standard delivery.
• Multilingual warning sticker sheet (residual voltage warning)
• Safety instructions
• Quick installation and start-up guide
• Hardware and firmware manuals, if ordered with a plus code.
Installing the drive
￭ To install the drive with screws
1. Make marks onto the surface for the mounting holes. Use the included mounting
template for frames R3 and R4. For other frames, see the dimension drawings.
2. Drill the holes for the mounting screws.
3. If necessary, install anchors or plugs into the holes.
4. Install the mounting screws into the holes. Leave a clearance between the screw
head and installation surface.
5. Put the drive onto the mounting screws.
6. Tighten the mounting screws.
Mechanical installation 41
To Next Page
Loading...
