ABB ACS800-02 - Removing the Pedestal (Frame Size R8)

Installation
51
Remove the pedestal (frame size R8):
1. Remove the lower front covers by undoing the fixing screws.
2. Press the left support leg a little down and turn it left. Let it lock down. Turn the right leg aside in the same way. The legs
will prevent the unit from falling down during the installation.
3. Undo the screws that fix the pedestal to the frame from front.
4. Undo the screws that connect the busbars of the pedestal to the upper frame. Use a torque wrench with an extension
bar.
5. Wheel the drive frame out by using the handle.
1
2
1
3
4
5
Red M10
combi screws
8 pcs or 9 pcs
Pedestal disconnected
3
with +D150