ABB CONCEPTPOWER CLASSIC DPA-50 - Page 4

Section-0
04-3008_CoverABB_OPMCPDPA-S2_GB_121202 Page 4/8 ABB
Printed in Switzerland – Modifications reserved
2 SECTION-2:
2.1 BLOCK DIAGRAM
2.1.1 WIRING AND BLOCK DIAGRAMS FOR ALL FRAMES AND MODULES
2.1.2 RECOMMENDED CABLE SECTIONS & FUSE RATINGS
2.1.3 BLOCK DIAGRAM CONCEPTPOWER DPA
TM
2.2 FRONT VIEW
2.2.1 FRONT VIEW OF MX-FRAMES
2.3 BATTERY CONNECTIONS
2.3.1 INTERNAL BATTERY MODULES
2.3.2 EXTERNAL BATTERY CABINET AND BATTERY CONNECTION
3 SECTION-3:
3.1 INTERFACING
3.1.1 SMART PORT JD1 ON EACH MODULE (SERIAL RS 232/SUB D9/MALE)
3.1.2 CUSTOMER INTERFACE AND DRY PORTS (VOLT-FREE CONTACTS)
3.1.3 JD11 / RS232 COMPUTER INTERFACE
3.1.4 JD12 / RS232 INTERFACE FOR MULTIDROP
3.1.5 USB/2 COMPUTER INTERFACE
4 SECTION-4:
4.1 OPERATION
4.1.1 COMMISSIONING
4.1.2 CONTROL PANEL
4.1.3 DESCRIPTION OF THE LCD
4.1.4 OPERATING MODES
5 SECTION-5:
5.1 OPERATION–PROCEDURES
5.1.1 START-UP PROCEDURE
5.1.2 SHUTDOWN PROCEDURE
5.1.3 LOAD TRANSFER: FROM INVERTER OPERATION TO MAINTENANCE BYPASS
5.1.4 LOAD TRANSFER: FROM MAINTENANCE BYPASS TO INVERTER OPERATIONS
5.2 REPLACEMENT OF UPS-MODULE
5.2.1 REPLACEMENT OF UPS-MODULE IN SINGLE-MODULE SYSTEMS
5.2.2 REPLACEMENT OF UPS-MODULE IN REDUNDANT MULTI-MODULE SYSTEM
5.2.3 REPLACEMENT OF A MODULE IN CAPACITY MULTI-MODULE SYSTEM