ABB CONCEPTPOWER CLASSIC DPA-50 - Mechanical Characteristics MX-Frames and Modules

Section-0
04-3008_CoverABB_OPMCPDPA-S2_GB_121202 Page 3/8 ABB
Printed in Switzerland – Modifications reserved
GENERAL CONTENTS OF THE
USER MANUAL CONCEPTPOWER DPA
TM
S2
0 SECTION-0:
0.1 FOREWORD
0.2 CONCEPTPOWER DPA™ S2 SYSTEM DESCRIPTION
1 SECTION-1:
1.1 MECHANICAL CHARACTERISTICS MX-FRAMES AND MODULES
1.2 SAFETY INSTRUCTIONS
1.2.1 GENERAL SAFETY INTRODUCTION
1.2.2 DESCRIPTION OF SYMBOLS USED IN THIS MANUAL
1.2.3 SYMBOLS, CONTROLS, AND INDICATORS
1.2.4 OPERATOR PRECAUTIONS
1.2.5 ENVIRONMENTAL CONSIDERATIONS
1.2.6 DECLARATION OF SAFETY CONFORMITY AND CE MARKING
1.2.7 INQUERIES
1.3 SYSTEM DESCRIPTION
1.3.1 GENERAL SYSTEM DESCRIPTION
1.3.2 CONCEPTPOWER DPA
TM
S2 BASIC SYSTEM CONFIGURATION
1.3.3 QUALITY STANDARDS AND UPS CLASSIFICATION CODE
1.3.4 SINGLE/PARALLEL-MODULES OPERATION
1.3.5 SINGLE/MULTI-CABINET CONFIGURATIONS
1.4 DELVERY - TRANSPORT - STORAGE
1.4.1 INTRODUCTION
1.4.2 RECEIPT OF THE UPS AND VISUAL INSPECTION
1.4.3 UNPACKING
1.4.4 NAMEPLATE AND IDENTIFICATION
1.4.5 BATTERIES AND STORAGE
1.5 SITE PLANNING AND POSITIONING
1.5.1 PLANNING BEFORE THE INSTALLATION
1.5.2 POSITIONING OF UPS AND BATTERY CABINET
1.6 ELECTRICAL INSTALLATION
1.6.1 PREPARATION FOR THE INPUT CABLING
1.6.2 INSTALLATION CHECKLIST