ABB Conceptpower DPA 500 - Page 42

04-3275_OPM_ABB_CONCEPTPOWER_DPA_500kW_EN_REV-A.docx Page 42/78 ABB
Modifications reserved
Service
This menu is reserved for certified service engineers. It is not to be used by end users and is protected by a
password.
UPS Measurements
Battery
Offset
UPS
Output Voltage (V)
Output Current (A)
Output Frequency (Hz)
Output Power (%)
Active Power L1 (kW)
Active Power L2 (kW)
Active Power L3 (kW)
Reactive Power (kVAr)
Apparent Power (kVA)
Inverter Voltage (V)
Bypass Voltage (V)
Bypass Frequency (Hz)
Rectifier Voltage (V)
Rectifier Temperature (
o
C)
Inverter Temperature (
o
C)
Udc Gain +
Udc Gain -
Run Time
Voltage + (V)
Voltage - (V)
Charge Current (A)
Discharge Current (A)
Temperature (
o
C)
I Battery Offset
Capacity(%)
V Battery Offset +
V Battery Offset -
Autonomy (min)
Type
Blocks
Cells
Floating Voltage (V)
Minimum Threshold
Common Battery
Start Fast Charge
Stop Fast Charge
P Load Offset L1
P Load Offset L2
P Load Offset L3
Q Load Offset L1
Q Load Offset L2
Q Load Offset L3
Inverter DC L1
Inverter DC L2
Inverter DC L3
Output DC L1
Output DC L2
Output DC L3
I Inverter Offset L1
I Inverter Offset L2
I Inverter Offset L3
I Bypass Offset L1
I Bypass Offset L2
I Bypass Offset L3
I Battery Offset
V Battery Offset +
V Battery Offset -
Type
Power
Unit Number
Slot ID
Cosphi
System
Parallel
Frequency
Sync Window
Inverter Voltage (V)
Rectifier Voltage (V)
General Alarm Delay
Converter
Separate Bypass
UPS Data
Commands
Tests
Manufacturing
Firmware Version
Hardware Version
Display Version
Dynamic Password
Clear Alarms
Service Mode
Standby Mode
Default Config.
Inverter Voltage
Open K Bypass
Close K Bypass
Upgrading from LCD to graphical interface
For substitution of past generations displays, certify that the UPS software version is compatible with the graphical
display. If that is not the case, upgrade the system to the newest software version. Then substitute the entire door of
the UPS and connect the display using the same connector as for the LCD control panel. All information from the
UPS (such as serial number, manufacturing date and version of the software and hardware) will be automatically
loaded to the new interface once it is connected to your UPS.