ABB Conceptpower DPA 500 - 11 Revision History

04-3275_OPM_ABB_CONCEPTPOWER_DPA_500kW_EN_REV-A.docx Page 80/78 ABB
Modifications reserved
11 REVISION HISTORY
Edition Date
Section(s)
Revision
19.08.2014
N/A
Second Release
07.10.2014
4 / 10
Changed the tightening torque
from: Max. tightening torque 26.4 Nm / (84.8 Nm)
to: Recommended tightening torque 24 Nm / (42 Nm)
6
6.2.3 Correct the DIP Switch SW 1-9 configuration
6.5.5 Correct the Definition of a Single/ Multi-Cabinet Chain table
(DIP Switch SW1-9)
150305
0
page 2, Correct the “CE” logo
2
2.2 Correct the “CE” logo
6.4
Update the entire chapter 6.4 with the new graphical display
10.6.1
Changed to display picture
REV-A
(30.03.2016)
0
Added the document information table
2.4
Corrected the dimensions w/o packaging in mm on the table 2
Corrected the standard packaging and wooden box weights on the table 3
5.1.2
Modified the “X1-Interlock function” row on the table
5.1.6
On the second sentence, corrected the phoenix terminal X2 with X3.
6.2.3
Modified the entire chapter 6.2.3 DIP-Switch configuration from a DIP-switch
SW1—9 to a DIP-switch SW1-6 (refer to the following release to more
information)
6.4.6
Corrected the reference from “see 6.2.3 navigation” to “see 6.4.4”
6.5.5
Corrected the DIP-switch table from DIP SW 1-9 to DIP SW 1-6
6.9
Corrected the point 1 sentence with “transfer the load to bypass on the control
panel of any module” instead “of three module”
10.6.2
Removed: see the user manual of the Conceptpower DPA S2 at the end of the
sentence
10.7.3
Modified the “Interlock castell function: Terminal block X1” chapter
11
Added the revision history inside the document
Last page
Moved the contacts details from the second page to the last one