ABB HT568964 - Table 33 Tightening Torque (56014)

Operation Manual / 4 Product description / A100-M axial
8
Di
sassembly and assembly Page 74 /
113
© Copyright 2016 ABB. All rights reserved.
HZTL4033_EN
Revision A
July 2016
Figure 43: Installing nozzle ring 2
Part number
A170-M
A175-M
56014 M10
50 Nm
M10
50 Nm
Table 33: Tightening torque (56014)
6. Undo nuts (61037) and remove guide plate (90328).
7. Undo screws (90339) and remove retaining plate (90338) with guide rod (90336).
8. Coat the threads of screws (56014) and the contact surface between screw and locking
washer with high-temperature grease.
9. Fit the nozzle ring (56001) on the gas inlet casing (51001) using the screws (56014) and
locking washers (56015).
10. Bend over locking washers (56015).