NoteAction
xx1000001103
Refit the cable gland cover at the cable exit with
its two attachment screws.
Note
Use a new gasket!
13
xx1000001102
Refit the motor cover with its attachment screws
and washers.
Note
Make sure the cover is tightly sealed!
14
xx1000001101
Remove the lock screw from the hole for lock
screw.
15
See section Performing a leak-down
test on page 142.
Perform a leak-down test of the axis 2 or 3
gearbox.
16
See section Changing oil, gearbox
axes 2 and 3 on page 126.
Refill the gearbox with oil.17
Continues on next page
Product manual - IRB 660 267
3HAC025755-001 Revision: W
© Copyright 2006-2020 ABB. All rights reserved.
4 Repair
4.6.2 Replacing motors, axes 2 and 3
Continued
To Next Page
Loading...
