ABB REC650 - Configurable Logic Blocks

PulseTime: Defines the pulse time duration. When used for direct tripping of circuit
breaker(s) the pulse time duration shall be set to approximately 0.150 seconds in order to
obtain satisfactory minimum duration of the trip pulse to the circuit breaker trip coils.
Used only for ModeOutputx: Pulsed.
OnDelay: Used to prevent output signals to be given for spurious inputs. Normally set to
0 or a low value. Used only for ModeOutputx: Steady.
OffDelay: Defines a minimum on time for the outputs. When used for direct tripping of
circuit breaker(s) the off delay time shall be set to approximately 0.150 seconds in order
to obtain a satisfactory minimum duration of the trip pulse to the circuit breaker trip coils.
Used only for ModeOutputx: Steady.
ModeOutputx: Defines if output signal OUTPUTx (where x=1-3) is Steady or Pulsed. A
steady signal follows the status of the input signals, with respect to OnDelay and
OffDelay. A pulsed signal will give a pulse once, when the Outputx rises from 0 to 1.
11.3 Configurable logic blocks
11.3.1 Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
OR Function block OR - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Inverter function block INVERTER - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
PULSETIMER function block PULSETIMER - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Controllable gate function block GATE - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Exclusive OR function block XOR - -
Section 11 1MRK 511 286-UUS A
Logic
272
Application manual