ABB REC650 - Time Synchronization

Events are also generated:
• whenever any setting in the IED is changed.
The internal events are time tagged with a resolution of 1 ms and stored in a list. The list
can store up to 40 events. The list is based on the FIFO principle, that is, when it is full, the
oldest event is overwritten. The list can be cleared via the local HMI .
The list of internal events provides valuable information, which can be used during
commissioning and fault tracing.
15.2 Time synchronization
15.2.1 Identification
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Time synchronization TIMESYNCHGE
N
- -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Time system, summer time begins DSTBEGIN - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Time system, summer time ends DSTEND - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Time synchronization via IRIG-B IRIG-B - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Time synchronization via SNTP SNTP - -
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Time zone from UTC TIMEZONE - -
Section 15 1MRK 511 286-UUS A
Basic IED functions
326
Application manual