ABB UNITROL 1020 - PC Software Tool; General; System Requirements for CMT1000 Release 6.300

 Chapter 6 - Operation
UNITROL 1020 User Manual 3BHS335648 E82 107
6.4 PC Software Tool
The PC software tool used with UNITROL 1020 is called CMT1000. Release 6.300 is
compatible with all previous 6.xxx releases but not with releases older than 6.000.
6.4.1 General
Parameter configuration and optimization can be done with the user-friendly software
CMT1000 for Microsoft Windows. CMT1000 accesses the UN1020 device through a serial
connection point-to-point via the USB or the Ethernet port, allowing access from remote
locations. The connection options to use CMT1000 are described in Chapter 3.3.9 –
Communication Ports.
Basic features of CMT1000
 Configuration of parameters
and I/O signals.
 Measurement reading
 Trending function for controller
optimization (Oscilloscope,
Power chart).
 Parameter File upload or
download.
 PID tuning, Setpoint step and
other powerful commissioning
tools.
The CMT1000 software operation is described in Chapter 6.4 – PC Software Tool.
6.4.2 System Requirements for CMT1000 Release 6.300
 Minimum Pentium 1 GHz or equivalent processor. Recommended: Pentium III or
Celeron 1 GHz or equivalent processor or higher.
 Minimum 512 MB RAM.
 Minimum screen resolution of 800x600 pixels. Recommended: 1024x768 pixels or
higher.
 CD-ROM drive.
 Microsoft
®
Windows
TM
XP, Vista or Win 7.
 Minimum 10 GB of free hard disk space.