Chapter 6 - Operation
158 3BHS335648 E82 UNITROL 1020 User Manual
In order to protect parameter changes by unauthorized persons, the customer can define
passwords to enter CONTROL mode to change parameters.
When hash is 1...9999, CMT will ask for a password before going to CONTROL mode. 0
means no password.
Setting for password, range 0 to 9999
0000 No password is active / default
4783 Default password, will work independently of any setting
Password will be asked when changing CMT from MONITOR to CONTROL mode. The
password is active for 10min
When CMT runs in MONITOR
mode, the password setting field
is grayed out.
When CMT runs in CONTROL
mode password can be set
6.4.8 Tune Menu
Adjust Setpoint, Trigger Setpoint, Status Displays
Tune \ Setpoint Adjust
It allows setpoint adjustment, step response tests and visualization of operating
modes, generator states, limiters and alarms status.
To Next Page
Loading...
