Chapter 4 - Installation and Storage
80 3BHS335648 E82 UNITROL 1020 User Manual
4.4 Mechanical Installation
The unit is mounted by means of four
screws.
See dimensional diagram for fixing holes
and spacing.
Mounting instructions see Chapter 3.3 -
Hardware
The unit should only be installed in indoor
areas which are dry and dust-free and
which do not contain any gases, acid
fumes or similar.
Mounting
The UNITROL 1020 is designed for
rack or wall mounting in upright
position.
A distance of approx. 50 mm around
the unit shall be kept free for optimal
cooling.
NOTICE!
Electrostatic discharge (ESD) can damage electronic boards and
components!
Do not touch printed circuit boards or other sensitive
components without taking static-sensitive handling
precautions.
Do not touch the components without wearing a wrist
grounding strap.
Put the board or component on a grounded working surface
which is protected against electrostatic discharges.
Hold a board only at the edge.
Handle a faulty board with care.
To Next Page
Loading...
