ABB UNITROL 1020 - Save Parameter File

 Chapter 6 - Operation
UNITROL 1020 User Manual 3BHS335648 E82 163
Proceed with following instructions.
1. Close all the pop-ups by clicking Continue
2. Disconnect the USB cable, after 5 seconds connect it again.
3. Go into CONTROL mode
4. Repeat the download
Help \ About CMT1000..
Shows SW and HW Revision and HW serial number
6.4.10 Save Parameter File
PC UNITROL 1010/1020
Write
Parameters
to EEPROM
Save
Parameter
File
Open
Parameter
File
Parameters
RAM
Parameters
EEPROM
LED lights up, if data RAM = EEPROM (MONITOR or CONTROL only)
EEPROM
HARD
DISK