Chapter 6 - Operation
126 3BHS335648 E82 UNITROL 1020 User Manual
in the window. The Sweep Buffer should be used together with the Instruments windows,
and therefore, it is only available when the CMT1000 is Offline. It can only be activated
from the menu when the cursors were already enabled as well.
Examples
a) During OFF LINE: previously stored waveform files
File \ Open Waveform: Open stored waveform file.
Adjust the Buffer Length if necessary to see the full
transient on the Oscilloscope.
Edit \ Cursors: Assign channel with buttons A and B, use left mouse
button to drag cursor A to the desired point on the signal
curve. The measured values can be measured on the
oscilloscope, instruments or PQ diagram.
Edit \ Sweep Buffer: The curves are run through from cursor point A using the
scanning bar.
b) During MONITOR or CONTROL: Real time data
Start: The recording of the waveform is started.
Freeze Waveform: The recording is stopped.
File \ Save Waveform: Save waveform.
File \ Save Setup: Save oscilloscope settings.
Notes
The window in "Tune" can also be opened to set the regulators.
The setpoint step is simulated in “Tune Setpoint Adjust“.
The buffer length can be adjusted from 1, 2, 5, 10, 20, 50, 100 and higher values
up to 500 seconds.
The time scale can be adjusted in the bar above the waveform (Zoom).
To Next Page
Loading...
