ABB UNITROL 1020 - Page 157

 Chapter 6 - Operation
UNITROL 1020 User Manual 3BHS335648 E82 149
AVR Date and Time
Setup \ AVR Time and Date
Adjust the time by means of the lower and raise buttons, then click Set AVR time
Set AVR to PC time: Click this button and the AVR will show the same time as in
Windows.
Data Logger
The Data Logger Setup can adjust
1 Sampling rate
2 Pre-Trigger value
3 Source
3 Extended Signal
The 7 basic signals are not listed, they are always active
 Generator Voltage
 Generator Current
 Reactive Power
 Excitation Current
 PWM
 Generator Status
 Generator Operation Mode