ABB VTR354P11 - Disassembly and Assembly

Turbocharger VTR..4 Seite / Page 1
Demontage und Montage Kap. / Chap. 5 Disassembly and assembly
ABB Turbo Systems Ltd
HZTL 10012
- M -
Volume: 63 pages
Edition: 10 / 2015

5
Demontage
und Montage
5
Disassembly
and assembly
Inhalt
1 Einleitung .................................................3
2 Gewichte ..................................................5
3 Turbolader abbauen
und anbauen ............................................9
4 Lager ausbauen und einbauen .............. 11
4.1 Verdichterseitiges Lager ausbauen ........ 11
4.2 Turbinenseitiges Lager ausbauen .......... 17
4.3 Turbinenseitiges Lager einbauen ........... 23
4.4 Verdichterseitiges Lager einbauen .........31
4.5 Masse K, K1, K2, Spiele L und M .........39
5 Rotor ausbauen und einbauen ...............41
5.1 Rotor ausbauen .....................................41
5.2 Turbinenschaufeln ersetzen .................. 49
5.3 Verdichter wechseln ...............................49
5.4 Rotor einbauen ......................................51
6 Abdeckring ersetzen ..............................53
7 Düsenring ersetzen ................................55
8 Heben Luftaustrittsgehäuse ..................56
9 Heben Gasaustrittsgehäuse .................57
10 Heben Gaseintrittsgehäuse ...................58
11 Heben Fuss ............................................ 59
12 Reserveteile ...........................................60
13 Tabelle der Anziehmomente ................... 63
Inhalt
1 Introduction ..............................................3
2 Weights ....................................................5
3 Removing and installing
the turbocharger ....................................... 9
4 Removing and installing the bearings .... 11
4.1 Removing the compressor end bearing . 11
4.2 Removing the turbine end bearing .........17
4.3 Installing the turbine end bearing ...........23
4.4 Installing the compressor end bearing ...31
4.5 Dimensions K, K1, K2,
clearances L and M ................................ 39
5 Removing and installing the rotor ..........41
5.1 Removing the rotor.................................41
5.2 Replacing the turbine blades .................49
5.3 Replacing the compressor .....................49
5.4 Installing the rotor...................................51
6 Replacing the cover ring ........................53
7 Replacing the nozzle ring ....................... 55
8 Lifting air outlet casing ..........................56
9 Lifting gas outlet casing .........................57
10 Lifting gas inlet casing ............................ 58
11 Lifting foot...............................................59
12 Reserve parts ......................................... 60
13 Table of tightening torques ..................... 63