ABL Wallbox eMH3 Installation Manual

| Installation – Installing and connecting the E3BLTE1
26
Proceed as follows:
1 Open the housing cover of the wallbox using the tri-
angular key and lower it.
T
T
T
2 Disconnect the wallbox from the electricity supply
via the integrated RCCB and MCB.
3 Locate the 5V USB switch of the SBC on the in-
side of the housing cover, and guide the cable tie
through the oval openings in the cover lining above
it.
MODBUS EN1 MODBUS
METER
M
E
T
E
R
C
N
T
R
L
CONTROL
CONTROL
METER
4 Insert the cable tie base into the opening located in
the area left of the USB switch.
MODBUS EN1 MODBUS
METER
M
E
T
E
R
C
N
T
R
L
CONTROL
CONTROL
METER
5 Degrease the area of the internal lining intended for
the antenna using an alcohol swab.
MODBUS EN1 MODBUS
METER
M
E
T
E
R
C
N
T
R
L
CONTROL
CONTROL
METER
6 Remove the rear protective foil from the LTE anten-
na and stick it to its intended position.

ABL Wallbox eMH3 Specifications

General

Model	eMH3
Manufacturer	ABL
Category	Automobile Battery Charger
Charging Power	22 kW
Number of Charging Points	1
Connector Type	Type 2
Installation	Wall-mounted
Communication	OCPP 1.6
IP Rating	IP54
Charging Current	32 A
Operating Temperature	-30°C to +50°C
Charging Power Options	Adjustable
Input Voltage	400 V
Output Voltage	400 V