If the pairing process was not successful, tap "Pair",
loosen the smoke alarm/heat detector from the base
plate, remove and replace the batteries.
Enter a name for the component.
Open the room list and select the room where the
component is installed. Tap the arrow to return to the
settings.
Now tap "Next".
Follow the instructions in the app and then complete the
process.
If the pairing process was not successful, tap "Pair"
and press the pair button on the back of the siren.
Enter a name for the component.
Open the room list and select the room where the
component is installed. Tap the arrow to return to the
settings.
Now tap "Next".
Follow the instructions in the app and then complete the
process.
If the pairing process was not successful, tap "Pair"
and press the camera hotkey on the Remote Key for
five seconds.