Turning RideMonitor™ Mode ON/OFF:
Your system was shipped with RideMonitor™
Mode enabled (ON). You may wish to disable
(OFF) or re-enable (ON) this feature. When
RideMonitor™ Mode is ON, the system will
Monitor the vehicle’s height whenever the IGN is
ON and make adjustments for changes in load
when deemed necessary. When this feature is
OFF, the system will only adjust when prompted
by pressing the height selection switch – It will
not Monitor the vehicle’s height and will not make
any adjustments for changes in load.
NOTE: RideMonitor™ Mode should be left ON
for maximum accuracy. The only case that it
should be turned OFF is if you feel that the
system is adjusting too often or inaccurately
while driving. In this case, rst try re-calibrating
the system using the instructions on Page 6. If
this does not solve the problem, turn the
RideMonitor™ Mode OFF and contact the
manufacturer for further assistance.
To Turn RideMonitor™ Mode (ON)/(OFF):
First, turn the Ignition OFF. Then hold “ ”
while turning Ignition ON.
If this feature was previously ON, then it will be
turned OFF and the “ ” Arrow will light
momentarily.
If this feature was previously OFF, then it will be
turned ON and the “ ” Arrow will light
momentarily.
OFF
ON
IGN
OFF
ON
IGN
Setup Programming:
To Next Page
Loading...
Need help?
General
