AccuAir e-Level - Setup Programming: Tank Pressure Mode Settings; Changing Tank Pressure Mode; Recalibration Required After Pressure Change; Setting Tank Pressure to 150 PSI

Setup Programming:
Tank Pressure Mode:
Your system was shipped with the Tank Pressure Mode set at 150 PSI. If you
have High Pressure Compressor(s) you can change the Tank Pressure Mode to
175 PSI or 200 PSI using the following Procedure:
Changing Tank Pressure To 150 Mode: (Factory Setting)
Hold the Program “ ” Button for approximately 3 seconds until both the
“ ” and “ ” Arrows ash; then Press the “ ” Button
5-Times to set the Tank Pressure Mode to 150 Mode.
The “ ” Arrow will turn ON when in 150 Mode.
Changing Tank Pressure To 175 Mode:
Hold the Program “ ” Button for approximately 3 seconds until both the
“ ” and “ ” Arrows ash; then Press the “ ” Button 6-Times to set
the Tank Pressure Mode to 175 Mode.
The “ ” and “ ” Arrows will turn ON when in 175 Mode.
Changing Tank Pressure To 200 Mode:
Hold the Program “ ” Button for approximately 3 seconds until both the
“ ” and “ ” Arrows ash; then Press the “ ” Button 7-Times to set
the Tank Pressure Mode to 200 Mode.
The “ ” Arrow will turn ON when in 200 Mode.
150 Mode:
• 110 psi ON /
150 psi OFF
175 Mode:
• 135 psi ON /
175 psi OFF
200 Mode:
• 160 psi ON /
200 psi OFF
Program Button
+
+
+
+
+
+
+
Program Button
+
+
+
+
+
+
Program Button
+
+
+
+
+
!
NOTE: The new Tank Pressure setting will NOT take affect until the system
is RE-CALLIBRATED using the procedure on page 6 or 7.