AccuAir Rocker Switch Manual V2.7 © 2007 AccuAir Control Systems, L.L.C.
- Page 8 -
ECU Mounting:
ECU Mounting Considerations
• The ECU is 100% weather-proof and can be mounted under vehicle next to
the valves.
• The ECU can be mounted upright or on its back as seen below. (If back
mounted, back tabs must be removed)
• The following diagrams illustrate both “Standard” and “Optional” mounting
congurations.
Bottom Mounting (Standard):
See ECU Mounting Template
on page 24.
Back Mounting (Optional):
See ECU Mounting Template
on page 26.
Step-by-Step
1.) Find a at location near the VU4 (Valve Unit) to mount the ECU.
2.) Plug-In the Valve Harness while nding the mounting position to make sure
that it reaches.
3.) Transfer hole pattern from the ECU Mounting Template on pages 24 & 26.
4.) Drill holes with a 3/16” drill bit and bolt the ECU down with the included
#10-32 Allen head cap screws.
For optional mounting,
remove back tabs with
diagonal cutters and a le.
To Next Page
Loading...