AccuAir Rocker Switch Manual V2.7 © 2007 AccuAir Control Systems, L.L.C.
- Page 6 -
Installation Overview:
After your Air Springs and Suspension Components have been installed, you can
begin installing the AccuAir components in the following order:
1.)
2.)
3.)
4.)
5.)
6.)
7.)
8.)
9.)
Install VU4 (Valve Unit)
Install ECU (Electronic Control Unit)
Install Height Selection Rocker Switch
Install Tank Pressure Sensor
Install Air Compressor(s)
Install Wiring Harnesses
Test Wiring and Mechanical Components
Install Ride Height Sensors
CALIBRATE SYSTEM
!
WARNING: Make sure to disconnect the vehicle battery ground
terminal throughout the wiring process.
To Next Page
Loading...