AccuEnergy Acuvim II series - Page 229

221
Fig 5-80
Fig 5-81
c). Set module address in the rst setting page. Press the "V/A" key to go to the
setting page. Users may set the parameters pointed out in Fig 5-89. The cursor
starts at the rst digit. The BACnet MS/TP Address’s default value is 0, and the
user dened range of address is 0~127. After setting the BACnet MS/ TP Address,
press the "V/A" key to accept. Press the "P" key to go to the second setting page
for the baud rate.