220
Fig 5-78
b). Press “P” key or “E” key to move the cursor to "Setting". Press “V/A” key to go
to the meter parameter setting mode. Device address page is the rst page of
“Setting” mode. It shows the Modbus address of the device for several seconds,
and then the screen goes to Access Code page. Press “V/A” key to go to the
parameter setting page. Press “P” key or “E” key to move the cursor to "NET".
Press "V/A" key to go to the BACnet module setting page.
Fig 5-79
To Next Page
Loading...
