3-50 Machine Maintenance Procedures
LVDS and Camera Cable Installation 0
1. Place LVDS and camera cable on the rear of the LCD panel. Refer to Figure 3-46.
2. Place the LVDS cable into the LCD panel connector (E) and secure the clear mylar tape
(D). Refer to Figure 3-49.
3. Adhere the yellow tape (C) to secure the LVDS cable in place. Refer to Figure 3-48.
4. Adhere the clear mylar tape (B) to secure the camear cable in place. Refer to
Figure 3-47.
5. Replace the adhesives to secure the LVDS and camera cable on the rear of the LCD
panel in place (Figure 3-46).
6. Install LCD panel.
To Next Page
Loading...
