3-6 FEATURES & SPECIFICATIONS
SB1391 Hardware and Setup Guide - Document revision no. 1.14
Guide Outline
Chapter 1 INTRODUCTION. Introduction to the control module.
Chapter 2 SAFETY AND EMC GUIDELINES
. Basic precautions and UL requirements.
Chapter 3 FEATURES & SPECIFICATIONS
. Primary features of the control module and
specification.
Chapter 4 MOUNTING AND WIRING
. Mounting information and electrical interface.
Chapter 5 WORKING WITH THE CONTROL UNIT
. Setting up, tuning, and programming the
control module.
Chapter 6 TUNING THE CONTROL LOOPS
. Detailed description of the control loops, how to
fine tune them, and how to implement dual loop control.
Chapter 7 HARDWARE INTERFACE PARAMETERS
. Motion monitoring and other
programming guidelines for the communication, feedback, and I/O.
Chapter 8 VECTOR CONTROL AND MOTORS
. Specialized topics for vector control for DC
brushless (AC servo/AC synchronous) and AC induction motors, and multiprogramming.
Note
For information developed after this guide was published, please refer to the
ACS-Tech80 web site (http://www.acs-tech80.com/
) or contact ACS-Tech80.
Related Documentation
Programming the control module is covered in the Software Guide.
To Next Page
Loading...