5-4 WORKING WITH THE CONTROL UNIT
SB1391 Hardware and Setup Guide - Document revision no. 1.14
Warning
It is recommended when activating the motor for the first time to disconnect it
from external loads and verify that the area is clear of any object that might be
hit by the moving motor.
Action Effect of action
Power on
the unit.
During power up, the MP_ON indicator flickers as the control processors
communicate with each other. The 7-segment goes on (i.e., displays an "8")
for a few seconds to show it is functioning properly and then goes off.
Once power up is complete, the MP_ON indicator remains on, showing that
the control processors are functioning properly. The VP indicator remains
on, showing that the power supply is functioning properly.
If the I/O supply has been connected, the V_OUT indicator remains on,
showing that the output power is present.
5.1.3. Installing ACS Software Tools
The unit comes with installation diskettes for ACS Tools, a suite of Windows applications for
setting up, adjusting, and programming.
TABLE 5-3 ACS Tools
Tool Description
ACS Adjuster Interactive tool for setting up and tuning.
ACS Debugger Development environment for ACSPL applications.
ACS Saver/Loader Tool for copying system setup and application data from
one controller to another.
Note
There are two sets of installation diskettes, one for ACS Adjuster and
ACS Debugger and one for ACS Saver/Loader.
Action Effect of action
1. Insert disk 1 of the ACS Tools
in the PC disk drive.
2. Double-click on Setup and
follow the onscreen
instructions.
The following ACS software tools will be installed in
the ACS Tools program group.
• ACS Adjuster
• ACS Debugger
To Next Page
Loading...