Action technology A3 - Page 4

4
earthquake happens.
malfunction or damage.
Provide an external emergency stop circuit to ensure that operation can
be stopped and power switched off immediately.
To prevent injury, electric shock, fire,
malfunction or damage.
Before wiring or inspection, turn off the power and wait for 5 minutes or
more.
To prevent electric shock.
Installing and wiring
Please follow the specified combination of the motor and drive.
To prevent fire or malfunction.
Do not touch the terminals of connector directly.
To prevent electric shock or
malfunction.
Do not block intake and prevent the foreign matters from entering into the
motor and drive.
To prevent electric shock or fire.
Fix the motor and have the test run away from the mechanical system.
After confirming the operation, the motor can be securely mounted to
mechanical system.
To prevent injury.
The servo motor must be installed in the specified direction.
To prevent injury or malfunction.
Install the equipment correctly in accordance with its weight and rated
output.
To prevent injury or malfunction.
Operation and running
Do not climb or stand on servo equipment. Do not put heavy objects on
equipment.
To prevent electric shock, injury, fault
or damage.
The parameter settings must not be changed excessively. Operation will
be instable.
To prevent injury.
When power is restored after an instantaneous power failure, keep away
from the machine because the machine may be restarted suddenly
(design the machine so that it is secured against hazard if restarted).
To prevent injury.
Keep it away from the direct sunlight.
To prevent malfunction.
Do not put strong impact on the motor, drive and motor shaft.
To prevent malfunction.
The electromagnetic brake on the servo motor is designed to hold the
servo motor shaft and should not be used for ordinary braking.
To prevent injury or malfunction.
Do not install or operate a faulty servo motor or drive.
To prevent injury, electric shock or fire
Check the power specification.
To prevent fault.
The electromagnetic brake may not hold the servo motor shaft. To ensure
safety, install a stopper on the machine side.
To prevent injury.
A sudden restart is made if an alarm is reset with the run signal on.
To prevent injury.
Connect the relay for emergency stop and for brake in series.
To prevent injury or malfunction.
Transportation and storage
Do not subject the equipment to the place with rain, waterdrop, poisonous
gases or liquids.
To prevent malfunction.
Do not carry the servo motor by the cables, shaft or encoder during
transportation.
To prevent injury or malfunction.