LAN Ethernet Ports (4)
The LAN Ethernet ports are used to connect computers to the R3000 via
Ethernet cable. The Ethernet ports are 10/100/1000 Mbps auto-sensing ports,
and either a straight-through or crossover Ethernet cable can be used when con-
necting to the ports.
WAN Ethernet Port
The WAN Ethernet port is used to connect the R3000 to a WAN via an
Ethernet cable.
USB Port
The USB port is used to connect the R3000 to a USB device. This port is not yet
active; it may be activated in a future firmware update.
Reset Switch
Depressing the Reset switch for one second will restore the R3000’s factory
default settings. To reset the R3000, depress and hold the Reset switch for
approximately ten seconds. The reset process will start after releasing the switch.
Power Port
The Power port is used to connect the Power cord to the R3000.
WARNING! Do not unplug the Power cord from the R3000 during the
reset process. Doing so may result in permanent damage to the R3000.
To Next Page
Loading...
Need help?
General
