Acura 1994 Integra - Page 1063

Heater
Valve
Gable
Adjustment
Disconnect
the heater
valve
cable from
the heater
valve
arm and the
clamp,
and from the heater
con-
trol
arm and the
clamp.
Set the temperature
control lever
to MAX. HEAT.
Turn the heater
control
arm as
shown. and
connect
the end of the
heater valve
cable to
the heater
con-
trol arm.
Gently slide the
heater valve
cable housing
back from
the
end enough
to take up
any slack in
the heater
valve
cable,
but not
enough to make
the tempera-
ture
control lever move.
Hold the
end of
the heater
valve
cable housing
against the stop,
then snap the
heater
valve
cable housing into
the
clamp.
2.
Air
Mix
Control
Cable
Adjustment
'l
. Disconnect
the
air mix control
cable
from
the
air max
control
arm
and the
clamp.
2.
Set the
temperature
control
lever to
MAX,
HEAT.
3, Turn
the air mix
control
arm as shown.
and
connect
the end
of the air mix
cont.ol
cable to
the
air mix
control arm.
4.
Gently
slide the
air mix control
cable
housing
back
trom
the end
enough to
take up
any slack in
the
air
mix controlcable,
but not
enough to make
the
tem-
pe.ature
control
lever move,
then
snap the
air mix
control
cable housing
into the
clamp.
NOTE: The
heater
valve
cable should
always
be ad-
justed
whenever
the air mix
control
cable has
been
disconnected.
HEATER
COIITBOL
ARM
HEATEB
VALVE
CABLE
AIR MIX
CONTROL
CABLE
AIB
MIX
CONTROL
ARM
5. Turn
the heate. valve
arm as
shown, and
connect
the
end of the heater valve
cable to
the heater valve
arm.
Gently slide the heater
valve cable housing
back from
the end
enough to take up
any slack in
the heater
valve
cable, but not
enough to make
the tempera-
ture
control lever
move, then
snap the heater valve
cable housing
into the
clamp,
NOTE:
The
air mix control
cable should
always
be
adjusted
whenever the
heater valve
cable has
been
disconnected.
CLAMP
21-27