Acura 1994 Integra - Page 341

Release Bearing
Installation
1. With the release
tork slid between
the release bear-
ing
pawls,
install the release
bearing on the main-
shaft while inserting
the release fo.k through the hole
in the clutch housing.
Align the detent ot the release fork
with the release
tork bolt, then
press
the release fork over the release
fork bolt.
NOTE;
Use
only Super
High Temp
Urea G.ease
(P/N
08798- 9002).
2.
-611
lPlN
08798-
-6
{P/N
0879a-
9002)
Move
the
release
fork
right
and
left
to make sure that
the
fork tits
properly
against the
release
bearing, and
that the release bearing slides smoothly.
4. lnstall the
release fork
boot.
12-12