▲▼ ▲▼
When your selection is successfully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to ‘‘AUTO
DOOR UNLOCK’’ and repeat the
procedure again.
Select the desired setting by
pressing the INFO ( / ) button,
then enter your selection by pressing
the SEL/RESET button.
Press the SEL/RESET button to
enter the selecting mode.
If you choose ‘‘DRIVER DOOR with
SHIFT to P,’’ you will see the above
display.
Press the INFO ( / ) button to
switch the door lock mode setting.
Then, press the SEL/RESET button
to enter your selection.
If you choose ‘‘DRIVER DOOR with
IGN OFF,’’ you will see the above
display.
Multi-Information Display
Instruments and Controls
107
A/T model is shown.
A/T model is shown.
To Next Page
Loading...
Need help?
General
