Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Turn on the lights to make sure
the new bulb is working.
Reinstall the trunk lid lining. Make
sure it is installed under the edge
of the trunk seal.
Insert the socket back into the
light assembly. Turn it clockwise
to lock it in place.
Install the fasteners.
Each outside mirror has side turn
signal lights. The lights should be
replaced by your dealer.
The license plate has two lights
above it. The bulbs should be
replaced by your dealer.
4.
5.
6.
7.
8.
9.
Lights
Side Turn Signal Lights
Rear License Plate Light Bulbs
Maintenance
437
SOCKET
To Next Page
Loading...
