Acura 2010 TSX - Replacing a Front Turn Signal;Parking and Side Marker Light Bulb

Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
To remove the burned out bulb,
push it in and turn it
counterclockwise until it unlocks.
Use a flat-tip screwdriver to
remove the holding clip from the
inner fender, and remove the
screw with a Phillips-head
screwdriver.
Pull the inner fender cover away
from the fender and bumper.
To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
left.
4.
5.
2.
1.
3.
Lights
Replacing a Front Turn Signal/
Parking and Side Marker Light
Bulb
434
SCREW
HOLDING CLIP
2010 TSX