▲▼
▲
▼
Memory Position Link
Press the SEL/RESET button to see
the selections.
Select ON or OFF by pressing the
INFO ( / ) button, then enter
your selection by pressing the SEL/
RESET button.
When your selection is successfully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘MEMORY POSITION LINK’’ and
repeat the procedure again.
If ‘‘MEMORY POSITION LINK’’ is
set to ‘‘ON,’’ the driver’s seat moves
to the position stored in the memory
(see page ) when you open the
driver’s door, using the remote
transmitter.
You can choose this item to
customize from ‘‘POSITION
SETUP’’ by pressing the INFO ( /
) button repeatedly.
142
Multi-Information Display
Instruments and Controls
93
To Next Page
Loading...
Need help?
General
