Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a 1/2
inch (12.7 mm) wide band across the
tread. This shows there is less than
1/16 inch (1.6 mm) of tread left on
the tire.
A tire this worn gives very little
traction on wet roads. You should
replace the tire if you can see three
or more tread wear indicators.
Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
Youshouldlookfor:
Bumps or bulges in the tread or
side of the tire. Replace the tire if
youfindeitheroftheseconditions.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see fabric or cord.
Excessive tread wear.
We strongly recommend that you do
not drive faster than the posted
speed limits and conditions allow. If
you ever drive in a sanctioned
competitive event at sustained high
speeds (over 118 mph or 190 km/h),
be sure to adjust the cold tire
pressuresasshownbelow.Ifyoudo
not, excessive heat can build up and
cause sudden tire failure.
Tire Size Cold Tire Pressure
Tire Size Cold Tire Pressure
4-cylinder models
6-cylinder models only
Tires
Tire InspectionHigh Speed Driving
448
TREAD WEAR INDICATOR
INDICATOR LOCATION MARK
P225/50R17 93V
P235/45R18 94V
35 psi (240 kPa ,
2.4 kgf/cm
)
35 psi (240 kPa ,
2.4 kgf/cm
)
To Next Page
Loading...
Need help?
General
