Turn on the lights to make sure
the new bulb is working.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Install the new bulb and turn it
clockwise to lock it in place.
Put the inner fender cover in place.
Install the holding clip. Lock it in
placebypushingonthecenter.
Tighten the screw securely.
Open the trunk.
Remove the light assembly cover
by pulling its outside edge.
Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.
Determine which of the three
bulbs is burned out: stop/taillight,
rear side-marker, or turn signal
light.
9.
7.
8.
6.
1.
2.
3.
4.
Lights
Replacing Rear Bulbs
(In Fenders)
Maintenance
435
COVER
To Next Page
Loading...
