This feature, when activated, replays
all files in the selected folder. To
activate folder repeat mode, select
FOLDER REPEAT by interface
knob, and press ENTER on the
interface selector. You will see
REPEAT next to FOLDER on the
screen. To turn this feature off,
highlight FOLDER REPEAT (if not
already highlighted), and press
ENTER on the interface selector
again.
Toselectanytypeoftherepeat
modes,usetheinterfacedial.For
more information, see page .
This feature, when activated,
samples the first file in each folder
for 10 seconds. To scan a folder,
press the SCAN side of the SCAN/
A. SEL bar repeatedly. You will see
SCAN next to FOLDER and the
folder number blinking.
To listen to the rest of the folder,
press and hold the SCAN side of the
bar until you hear a beep. If you do
nothing, the system advances to the
next folder, plays 10 seconds of it,
and continues with the remaining
folders in the same way. When the
system has finished sampling the
first file in all folders, folder scan is
canceled, and the last file played
continues to play.
If the root folder has some additional
folders in the lower layer, they will
belistedonthescreen.
You can see the list of all the files in
the selected folder. Turn the selector
knob, then press ENTER to set your
selection.
249
Folder RepeatFolder Scan
Playing Discs (Models with navigation system)
Features
253
CURRENT TRACK
To Next Page
Loading...
Need help?
General
