On success you will see something like this white text output and the message Done
compiling. in the message area.
Upload Sketch
Once the code is verified/compiling cleanly you can upload it to your board. Click the
Upload button.
The IDE will try to compile the sketch again for good measure, then it will try to
connect to the board and upload a the file.
This is actually one of the hardest parts for beginners because it's where a lot of
things can go wrong.
However, lets start with what it looks like on success! Here's what your board upload
process looks like when it goes right:
this and then provide all the text that is output. It can assist in nailing down what
happened!
©Adafruit Industries Page 200 of 263
To Next Page
Loading...
