The Component Picker lists all the available components, sensors, and parts, which
can be used with the WipperSnapper firmware. Your Feather board already has a LED
built-in, so there's no wiring for you to configure.
Click theLED component.
Feathers contain GPIO pins that can be configured either as an input or an output.
The "Create LED Component" screen tells WipperSnapper to configure a general-
purpose output pin connected to the LED on your Feather as a digital output so you
can turn the LED on or off.
The ESP32-S3 TFT Feather has a built-in LED located at D13 (LED). Select this pin as
the LED Pin and click Create Component.
©Adafruit Industries Page 238 of 263
To Next Page
Loading...
